In 2002 we introduced the R-122, the world’s first phantom powered, active ribbon™ microphone. It was a revolutionary development in ribbon mics, combining impedance matching circuitry with condenser-like output levels that allowed the R-122 to be used on even the quietest sound sources. It also allowed the mic to be paired to virtually any preamplifier.
The R-122 MKll takes the R-122 to a whole new level, delivering unprecedented flexibility for ribbons via the addition of a switchable -15 dB pad and a switchable bass-cut filter. The switches are completely out of the circuit when disengaged so when both are off, the microphone is for all purposes an original R-122. The switches are located on the back of the microphone and recessed to prevent accidental activation.
Features
-
Phantom powered circuitry provides high output and impedance matching
-
-15 dB pad before the mic’s electronics gives more headroom when activated.
-
Bass cut filter reduces proximity effect and bass below 100 Hz when activated
-
High SPL Capabilities
-
No distortion up to maximum SPL rating
-
Extremely low residual noise
-
Ribbon element is not affected by heat or humidity
-
Absence of high frequency phase distortion
-
Equal sensitivity from front or back of element
-
Consistent frequency response regardless of distance
-
Rear side of mic records slightly brighter when three feet or closer to sound source
Specifications
-
Acoustic Operating Principle: Electrodynamic pressure gradient with active
-
electronics.
-
Polar Pattern: Figure-8
-
Generating Element: 2.5-micron aluminum ribbon
-
Magnets: Rare Earth Neodymium
-
Frequency Response: 30 - 15,000 Hz ±3 dB
-
Sensitivity: -36 dB (re. 1v/pa ±1 dB)
-
Switchable Pad: -15 dB
-
Switchable Bass Cut: 100 Hz (6 dB per octave)
-
Self-Noise: < 18 dB
-
Output Impedance: 200 Ohms, balanced
-
Output Connector: Male XLR 3-pin (Pin 2 Hot)
-
Rated Load Impedance: 1K-Ohm minimum
-
Maximum SPL : 135 dB @ 30 Hz
-
Power Requirements: 48-Volt Phantom Only
-
Supply Current : 4 mA
-
Dimensions : 206mm L X 25mm W (8 1/8” L X 1” W)
-
Weight : 309 grams (10.9 oz)
-
Finish : Burnished Satin Nickel / Matte Black / Chrome (optional)
-
Accessories : Protective wood case, mic sock
-
Optional Accessories : Wind screen, shock mount
-
Microphone Warranty : Lifetime to original owner (repair or replace at Royer’s option)
-
Ribbon Element Warranty : One Year