Inductor EQ/Compressor Module with 3-band EQ and Selectable Feed-forward or Feedback-style VCA Compression - Fits 5285 Vertical Frames or 5088 Consoles.
หมายเลขสินค้า : 5051
ราคา 89,730.00 บาท
ราคาปกติ : 133,000.00 บาท
ประหยัดไป 43,270.00 บาท
-
ตรวจสอบก่อน! ว่ามีสินค้าหรือไม่
-
*กรุณาโทรเช็คสต็อคสินค้าก่อนสั่ง 061-649-9144
เลือกจำนวน :
เลือกสี : Black
-
ฟรี!
ประกัน 1 ปี
-
ฟรี!
ปรึกษาด้านเทคนิก
แชร์ไปยัง :
Inductor EQ/Compressor Module with 3-band EQ and Selectable Feed-forward or Feedback-style VCA Compression - Fits 5285 Vertical Frames or 5088 Consoles.
อีควอไลเซอร์,คอมเพรสเซอร์ Neve Shelford 5051 combines a classic 3-band EQ based on Rupert’s vintage designs with the power and flexibility of the Portico II compressor
The Rupert Neve Designs Shelford 5051 Inductor EQ and Compressor combines the classic 3-band EQ from Rupert Neve’s vintage circuit designs with the flexibility and power of the Portico II compressor. Using a fully discrete class-A signal path combined with high-performance input and output transformers, the combination EQ and compressor upholds the world renown reputation of the master circuit designer.
The EQ section
of the module uses a custom-tapped inductor with selected capacitors to form the mid-range equalizer band and the shelf curves are based on Neve’s vintage Modules. Each of the EQ sections uses a low feedback class-A discrete electronics to prevent low-level artifacts from distracting from the tonal shaping of your signal.
The high and low bands can be switched from shelf to peak curves and both offer 15 dB of boost or cut. The high band can be switched from 8,000 to 16,000 Hz and the low band can be set to 35, 60, 100, or 220 Hz. The mid band offers six center frequencies at 200, 350, 700, 1500, 3000, and 6000 Hz.
The mid band also features a high peak switch to narrow the bandwidth or increase the Q of the filter. An 18 dB/octave high-pass filter with two corner frequencies that can be toggled between Off, 60, and 120 Hz.
The EQ can be switched to pre or post compressor in the signal chain. It also allows for the two XLR balanced inputs on the back of the unit to be switched from the front panel which allows setups such as having a mic preamplifier and a line input from a DAW to be pre-patched and selected at will.
The compressor section
of the module uses a discrete class-A signal path from the Portico Series of signal processors with individual control over threshold, attack, release, make up gain, ratio, side chain HPF, Feed-Forward/Feed-back selection and Peak/RMS detection modes. If you deactivate the compressor the unit can be used as a transformer-coupled high-performance line amplifier.
The compressor has the ability to switch between feed-forward and feed-back operation, and two modules can be linked together for stereo operation. The unit is intended for use with 5088 consoles or with 5285 vertical frames.
There are two ±24V power supply options. One 5-way power supply can be placed at the bottom of the rack or a separate 25-way power supply in a 2U enclosure may be used. Using the external module provides clean power with less heat build-up within the modules associated with the DC to DC up-conversion.
Features:
- Classic Neve EQ Sound
- Compressor Design from Portico Series
- Discrete Class-A Circuit Design
- Selectable HF Shelf or Peak Filter
- Mid-Band Parametric EQ
- Side Chain High-Pass Filter
- EQ Before or After Compressor
- Feed-Forward/Feed-Back Operation
- Link Two Modules for Stereo Operation
- Two Ways to Power
Specifications
LINE IN
FREQUENCY RESPONSE
Main Output, no load.
-3 dB @ 2.5 Hz
-3 dB @ 125 kHz
NOISE
Measured at Main Output, unweighted, 22 Hz - 22 kHz.
Terminated 40 Ohm, With gain at unity: better than -102 dBu
MAXIMUM INPUT
20 Hz to 20 kHz: +25 dBu
MAXIMUM OUTPUT
20 Hz to 20 kHz: +25 dBu
TOTAL HARMONIC DISTORTION AND NOISE
From <10 Hz to 80 kHz.
@ 1kHz, +20 dBu output: Better than 0.002%
@ 20Hz, +20 dBu out: Better than 0.120%
@ 20kHz, +20 dBu out: Better than 0.010%
EQUALIZER
NOISE
Measured at Main Output, unweighted, 22 Hz-22 kHz. Terminated 40 Ohm with all gains set at 0.
Better than -92 dBu
MAXIMUM INPUT
20 Hz to 20 kH: +24.5 dBu
MAXIMUM OUTPUT
20 Hz to 20 kHz: +24.5 dBu
TOTAL HARMONIC DISTORTION AND NOISE
From <10 Hz to 80 kHz.
@ 1kHz, +20 dBu output: Better than 0.007%
@ 20Hz, +20 dBu out: Better than 0.120%
@ 20kHz, +20 dBu out: Better than 0.070%
COMPRESSOR (Threshold at +20 dB, Ratio at 1.1:1, Gain at 0.)
NOISE
Measured at Main Output, unweighted, 22Hz - 22kHz. Terminated 40 Ohm.
Better than -92 dBu
MAXIMUM INPUT
20 Hz to 20 kHz: +25 dBu
MAXIMUM OUTPUT
20 Hz to 20 kHz: +25 dBu
TOTAL HARMONIC DISTORTION AND NOISE
From <10 Hz to 80 kHz.
@ 1 kHz, +20 dBu output: Better than 0.020%
@ 20 Hz, +20 dBu output: Better than 0.140%
@ 20 kHz, +20 dBu output: Better than 0.070%
THRESHOLD
Continuously Variable from -30 dBu to +20 dBu
RATIO
Continuously Variable from 1.1:1 to 40:1
GAIN
Continuously Variable from -6 dB to +20 dB
ATTACK
Continuously Variable from 20mS to 75mS
RELEASE
Continuously Variable from 100mS to 2.5 Seconds
UNIT DIMENSONS
9.375” H x 1.75” W
ไม่พบข้อมูล
เปิด จันทร์ - อาทิตย์
เวลา 9.30 - 18.30 น.
32 ซอยรามคำแหง 24 แยก 30 (หมู่บ้านศิขริน) แขวงหัวหมาก เขตบางกะปิ กรุงเทพมหานคร 10240
บริการให้คำปรึกษา
English Version : 082-623-6663